Difference between revisions of "Upload bootloader"

From Flav's Wiki
Jump to: navigation, search
Line 46: Line 46:
  
 
=Flash optiboot=
 
=Flash optiboot=
Read: http://yveaux.blogspot.tw/2014/07/changing-arduino-bootloader-to-optiboot.html
+
Read:  
http://sensortesthome.blogspot.kr/2015/03/using-optiboot-for-arduino-pro-mini-33v.html
+
*http://yveaux.blogspot.tw/2014/07/changing-arduino-bootloader-to-optiboot.html
 +
*http://sensortesthome.blogspot.kr/2015/03/using-optiboot-for-arduino-pro-mini-33v.html
 +
 
 +
=Upload Issues=
 +
*Fuse Settings: http://www.martyncurrey.com/arduino-atmega-328p-fuse-settings/
 +
*Issues: http://www.gammon.com.au/forum/?id=11643

Revision as of 10:36, 12 July 2015

This page describes how to upload a bootloader on an Arduino Pro Mini with an Arduino Uno.

References:

Hardware Connexion

Arduino Uno (Programmer) Arduino Pro Mini
3.3V or 5V (depending on on Mini version) Vcc
GND GND
10 Reset
11 (MOSI) 11 (MOSI)
12 (MISO) 12 (MISO)
13 (SCK) 13 (SCK)

Programming with IDE

Disconnect the Arduino Pro Mini

Program the programmer

Steps:

  1. Select the ArduinoISP Sketch: Select File>Examples>Arduino ISP
  2. Select your programmer board (Arduino Uno): Tools>Board>Arduino Uno
  3. Select the serial port: Tools>Serial Port>COMXXX
  4. Upload

Connect the Arduino Pro Mini

Flash the bootloader

Steps:

  1. Select the target board: Tools>Board>Arduino Pro Mini ...
  2. Select type of programmer: Tools>Programmer>Arduino as ISP
  3. Burn: Tools>Burn Bootloader

Flash optiboot

Read:

Upload Issues